The Manual control utility provides you with the items for checking various types of operations and for checking the ON/OFF status of each sensor.
The Functions such as changeover of a PWB, moving of a head and checking of laser are mainly used. In addition, you can check an LED that may malfunction(with turning it on and off).
Control Menu:
1, Head

• Head control: XY axes movement control and display in X and Y coordinates relative to each head. Z and Θ axes movement control and coordinate display of each head vacuum control, blow control, and pressure value display of each head.
• Head device control: XY axes movement control and display in X and Y coordinates of each head device (OCC, bad mark sensor, HMS). Control of each head device and display of sensor status.
• Laser control: Vacuum control of each head, and vacuum ON/OFF display Z axis movement control and coordinate display of each head algorithm change  Measurement and result display image         display  Edge check and Edge check display.

2, Conveyor

• Independent control of conveyor: Stopper control, Y-clamp, Support table control, ready out control, board available out control, conveyor motor control, PWB detect pin, each sensor of transport system and signal status display.
• Automatic control of conveyor: Automatic transport control, each sensor of transport system, signal status display, and movement control between the PWB stations.
• Auto width conveyor control: Automatic PWB width alignment operation control, display of the PWB transport width  Status display of each conveyor sensor.
• Y table control: Return of the Y table to its home position, movement of the Y table to the desired position and display of the coordinates.

4,Feeder

• Feeder knock pin control: Control of the feeder knock pin and control of the feeder position indicator

5, Other

• ATC control: ATC slide plate control, sensor status display, and nozzle suction control
• Signal light control: Signal light control, buzzer control, and status display
• Calibration block control: LED control, vacuum control and state display
• Other sensors: Status display the temperature sensor, etc,
• Driver status: Status display of the X, Y, Z, and theta axes drivers
• Servo Status: Servo status indicated with a picture