CURRENT LOCATION:HOME > NEWS > Industry News >
  • How to deal with SMT's poor tin plating?

    Wave crest: the surface of a wave is covered by a layer of oxide that remains almost stationary along the length of the solder wave, In the process of wave soldering, PCB contact to the front surface of tin wave, oxide breakdown, tin wave in front of   [Read More]
    Jan 04, 2022

  • vacuum value without nozzle

    This menu command allows you to set vacuum value of each head on which no nozzle is mounted. This setting causes the system to check a deviation of the cacuum values of heads. If the value changes greatly by comparing with the value set at delivery of the  [Read More]
    Jan 03, 2022

  • 8 steps need to set a nozzle?

    Setting items 1) Noz. No. ( Nozzle No. ) Set the nozzle number to be assigned to the ATC. 2) Type ( Nozzle Type ) Set the type of a nozzle to be assigned to the ATC. Available nozzle types: a; normal ( Normal Nozzle) b; T-type ( Cleaner type nozzle) c  [Read More]
    Jan 03, 2022

  • How to set a nozzle?

    How to set a nozzle? The reference head on which a nozzle is mounted measures the height of the nozzle tip (measured value is to be entered into the Noz. height field) and nozzle width ( to be entered into the Noz. No. ) with laser. In addition, the refer  [Read More]
    Jan 03, 2022

  • ATC Nozzle Setup

    Setting Group When you select the setting group command from the menu bar, the following items appear on the displayed menu. ATC nozzle setup This menu command allows you to set information on each nozzle mounted on the ATC. When you select this ATC n  [Read More]
    Jan 01, 2022

  • How to register customized nozzle data into mounter?

    Registered nzl. no table This command displays the list of the nozzles already registered and their information on the screen. When you select the Registered nzl. no table command from the filemenu, the Registered nozzle no. table dialog box appears o  [Read More]
    Jan 01, 2022

  • How to do maintenance of the nozzle?

    Cleaning of the nozzle(Tool to be used: Ultrasonic cleaner) 1, Dampen the entire nozzle whose number is from 500 to 504, 509 in alcohol, and clean it with an ultrasonic cleaner or similar tool for five minutes. 2, To prevent the urethane section of th  [Read More]
    Dec 28, 2021

  • Inspecting Vacuum Filter for dirt

    Checking the filter for dirt 1) Check the vacuum pressure by the negative pressure gauge provided at the front of the equipment when the vacuum pump is in operation. * Check it when a vacuum operation is not in progress. 2) If the value indicated with  [Read More]
    Dec 28, 2021

  • Maintenance of transport screw shaft(shaft)

    Transport screw shaft(shaft): 1 Screw shaft on each side, right and left. Apply grease to the entire surface of screw shaft. Tool to be used: Brush Grease to be used: 6459 Grease N Transport guide shaft: 2 Guide shaft: 2 on the left, 3 on the right. A  [Read More]
    Dec 28, 2021

  • How to lubrication nozzles?

    Applying of oil to a nozzle after cleaning it by air gun, cotton swab and waste cloth. If you leave the nozzle without doing anything to it after cleaning it, the inside of the nozzle may be rusted. Follow the procedure below to apply oil to the nozzl  [Read More]
    Dec 28, 2021

|<12345>| Page 1 of 5