-
Inspecting and Replacing the transport pulley
When the pulley does not rotate well, Check and replace the transport pulley by driver and wrench [Read More] Dec 26, 2021
-
How to replace juki transport belt?
Check to see if the transport belt is not worn out, damaged or stretched [Read More] Dec 26, 2021
-
Inspecting Air filter
Check to see if the air filter is not stained [Read More] Dec 26, 2021
-
How to checking piping and joint?
1, Check that there is no air leakage. [Read More] Dec 26, 2021
-
How to Check and replace the filter
Check to see if the optional filter is stained i Check to see if the red mark of the clogging checker is not raised ii If the filter is clogged, replace the filter element with a new one Four steps to replace of the optional filter element: 1, loosen [Read More] Dec 26, 2021
-
How to check air pressure of JUKI machine?
Check the original air pressure and the drain [Read More] Dec 26, 2021
-
How to deal with common errors of KE2070 KE2080
Belows are KE2070 KE2080 common errors, and causes and corrective action: 1, Symptom: The START/STOP Switches cannot function Cause: When the cover on the side opposite to these switches is opened, they are disabled for safety. Corrective action: Clos [Read More] Dec 19, 2021
-
Vision Recognition Errors
Vision Recognition Errors 1, The VCS Camera is stained. - Clean the VCS Camera. 2, Vision Data creation error. This error occurs more frequently due to lead (ball) pitch and number of leads (balls) entry errors. Be sure to enter the lead pitch and number [Read More] Dec 19, 2021
-
Mark ( BOC Mark/IC Mark) Recognition Errors
Mark ( BOC Mark/ IC Mark) Recognition Errors: 1, A Mark is stained - Manage marks so that they cannot be staied. set the noise cut level of a mark again. 2, Data entry error of the X and Y coordinates of a mark. -Specify the X and Y coordinates of a mark [Read More] Dec 19, 2021
-
Nozzle Attachment / Detachment Error
Nozzle Attachment / Detachment Error 1, The surface of the laser sensor is stained. - Clean the surface of the laser sensor. 2, The ATC is stained - Clean the ATC. Clean dust and grease from the ATC. 3, The nozzle is not installed onto the ATC firmly. In [Read More] Dec 19, 2021
Professional Supplier Of SMT Spare Part& SMT Machine & SMT Peripherals
Address : Building A,TianYou Industrial Park, FuYong,ShenZhen,GuangDong ,China
Email : info@kingfeismt.com
Email : info@kingfeismt.com
