LNC60 (Laser Unit): This is a laser unit that finds the center of a component (centers a component). (It can center six components at the same time.)
Head: This device picks up, centers and places a component. The machine is equipped with six (LNC60 heads" and one "IC head" (for a KE-2080/2080R).
Offset correction camera (OCC): This is a camera that checks a mark and/or component placement coordinates on a board and/or adjusts the mark or component placement position.
Bad Mark Reader: This is a sensor that reads a symbol (bad mark) marked on a defective board(circuit) in case of a multi-circuit board. The machine does not place a circuit on which a bad mark is marked on a board.
Auto Tool Changer(ATC): This is a unit that stores nozzles.
Height measurement system(HMS): This is a sensor that measures the height of a board or a component mainly.
Nozzle: This is a unit that is to be attached on the tip of the head(LNC60 head or IC head) to pick up a component.
Coplanarity: This is a sensor that detects a lead float error of a component having a lead(s),
Vision centering system(VCS): THis is a camera that finds the center of a component having a lead(s) or a ball(s).
Support Table: This is a table that supports a board. When a support pin is used, the stability improves.
Feeder bank: This is the base on which a component supplying device such as a tape feeder is to be attached on.
Tape Feeder: this is a component supplying device that supplies chip components or other type of components to be placed on a board.
Overall feeder exchange trolley: when a component supplying device such as a tape feeder is attached on this trolley and the whole trolley is set on the machine for changeover of PWB production, the required time for changover can be shortened.
Handheld operating device( HOD): THis is an operation panel for performing operations such as adjustment of the component placement coordinates on a board(teaching) with each unit(such as an OCC).