Component placement angle error

1, Data entry error in the " angle" field of the " placement" data screen

    Enter the component placement angle again

2, Data entry error in the " supply angle" field of the " component" data screen. The component placement angle for PWB production is calculated with the expression: " supply angle" ( set on the " component" data screen)+ " Angle" (set on the " placement" data screen) according to the packaging style of a component.

    - Set the " supply angle" on the " packaging stype" tab invoked from the " component" data screen again

3, Nozzle selection error
   Since the system cannot pick up a component stably in this case, the component placement angle and/ or placement coordinates tend to vary.
   
   - Select a nozzle again.  Select a nozzle that can pick up a component stably.  Normally, select the large nozzle among nozzles that can pick up a component with considering the picked-up area of a component.

4, For a long connector, the speed for rotating the theta axis is fast with considering the area to be picked up by a nozzle. Since the system cannot pick up a component stably also in this case, the component stably      also in this case, the component placement angle and / or placement coordinates tend to vary.

   - Decide if a customized nozzle should be used. or, select " med." or " low" in the " theta" field on the " expansion" tab invoked from the " component" data screen.