40045547 JUKI 2070 LNC60 Laser Unit

This is a laser unit that finds the center of a component (centers a component).
It can center six components at the same time.
Suit for JUKI 2070 2080 FX-3 JX300 Machine

How often to clean the LNC60 Laser?
CyberOptics recommends cleaning the sensor windows once every three months.
If often use, it may be necessary to clean them more often.
But pay attention, more frequent cleaning is discouraged due to improper cleaning may damage the laser window.

Why need cleaning LNC60 Sensor windows?
LNC60 optical windows are exposed and should be treated and cleaned with the same caution.

Normal cleaning procedure:
Under normal operating conditions, dust and debris can accumulate on the LNC60 windows, To remove this dust, CyberOptics recommends as below:
Brush dust off the sensor windows using a camel-hair brush or a brush made of a material designed for cleaning optical surfaces.

Cleaning procedure for persistent problems
Use the following procedure to remove fingerprints or other oily deposits that are not removed using normal cleaning procedures.
1, Moisten a lint-free tissue or cotton swab with a small amount of isopropyl alcohol or acetone.
2, Wipe each window once with the moistened tissue or swab in a single direction.
warning: wiping back and forth may re-deposit the debris and may damage the window.
3, Using a dry tissue or swab lightly wipe each window in a single direction to remove any remaining alcohol residue.